Are you looking for a lock to keep your flexible shaft protective sleeve from moving?
We have developed these locks to anchor a point on your drain cleaning shaft. This is a shaft lock (a new version of the brush locks).
Prevent the sleeve from moving
Too much exposed flex shaft near the drill is a weak point because if the shaft should stop suddenly, and the torque limiter does not engage in time, the exposed section of shaft is the most likely place where the shaft could kink. Keep the section of exposed drain cleaning shaft (without a sleeve) near the drill end of your shaft to a minimum with this shaft lock.
Whilst the sleeve movement has very little impact on your shafts performance, some clients prefer to have an exposed section of shaft (without the sleeve) on the tool end. This lock will allow you to achieve this.
Protect your chains
Feedback from clients indicates that some clients add a shaft lock to the front or in the middle of their drain chains (without a drill head) to give the chain a beveled surface when navigating around elbows in drain pipes.
Please note that we sell them as a set of two locks. i.e a pair.
The locks are made from stainless steel to prevent corrosion, and they are tightened on to the flexible shaft with set screws.
|Shaft Lock for 6mm (1/4″) Shaft – 16mm diameter – 12mm long
|Shaft Lock for 8mm (5/16″) Shaft – 18mm diameter – 12mm long
|Shaft Lock for 10mm (3/8″) Shaft – 20mm diameter – 12mm long
|Shaft Lock for 12mm (1/2″) Shaft – 22mm diameter – 12mm long
Points to note:
These products are intended to be used by trained professionals in the sewer cleaning trade. They do not come with instructions. If you would like training please make contact with us, and we will guide you.
Product pictures may vary in colour and design depending on the size and diameter that you order.